Note! | t
| Only remove the new cylinder head gasket from its packing immediately before installing. |
| t
| Handle the new gasket with extreme care. Damaging will lead to leaks. |
| –
| Place a clean cloth in cylinders so that no dirt or emery cloth particles can get in between cylinder wall and piston. |
| –
| Carefully clean cylinder head and cylinder block sealing surfaces. Thereby ensuring that no scoring or scratches are formed (when using abrasive paper the grade must not be less than 100). |
| –
| Carefully remove metal particles, emery remains and cloths. |
| –
| Set No. 1 cylinder piston to TDC and then turn crankshaft back slightly. |
| –
| Fit new cylinder head gasket. Lettering (Part No.) must be readable. |
| –
| When doing this observe the centralizing pins in cylinder block. |
| –
| Fit new cylinder head bolts and tighten by hand. |
|
|
|
