Leon Mk2
Ignition system components: removal and installation |
Note!
t | Note: |
t | Engine control unit* with connectors → Item. |
1 - | H.T. cable |
q | With suppression connector and spark plug cap |
q | Resistance 4.8...7.2 kΩ |
2 - | Ignition transformer -N152-* |
q | Location → Chapter, engine bay fitting plan |
q | Marked for H.T. cables: A = Cylinder 1 B = Cylinder 2 C = Cylinder 3 D = Cylinder 4 |
q | Checking → Chapter |
3 - | Connector |
q | Black, 4-pin |
q | For ignition transformer -N152- |
4 - | 10 Nm |
5 - | Connector |
q | Black, 2-pin |
q | For knock sensor 1 -G61- |
q | Gold terminal contacts |
6 - | Knock sensor 1 -G61-* |
q | Location → Chapter, engine bay fitting plan |
q | Checking → Chapter |
q | Gold terminal contacts |
7 - | 20 Nm |
q | Tightening torque influences the function of the knock sensor |
8 - | Connector |
q | Black, 3-pin |
q | For Hall sender -G40- |
q | Gold terminal contacts |
9 - | Hall sender -G40-* |
q | Location → Chapter, engine bay fitting plan |
q | Checking → Chapter |
10 - | O-ring |
q | Renew if damaged |
11 - | H.T. cable guide |
12 - | Spark plug, 30 Nm |
q | Remove and install with spark plug spanner -T20028- |
q | Type and electrode gap → Chapter, test data, spark plugs |