Indicated on display: (1...4 = Display fields) |
–
| Observe coolant temperature value in display zone 2, whilst engine is running. The temperature figure must increase uniformly and without interruption. |
Note! t
| If the display on fault reader jumps by 2...5 °C, it is a control unit fault and not caused by a defective sender. |
t
| If irregular engine running occurs in certain temperature ranges and the temperature figure does not increase without interruption, the temperature signal is temporarily interrupted and the sender must be renewed. |
–
| Press keys 0 and 6 for the “End output” function and confirm input with the Q key. |
If the specification is not obtained: |
–
| Replace coolant temperature sender -G62- with coolant temperature gauge sender -G2- → Item. |
|
|
Read measured value block 1 → | |
|