Leon Mk2
Functions which can be selected when using the fault reader -V.A.G 1551/1552- |
The prerequisites for selecting the desired functions can be determined from the following table. |
Function | Prerequisite | ||
Functions of -V.A.G 1551-, -V.A.G 1552- | Engine stationary, ignition switched on | Engine running at idling speed | |
02 | Interrogate fault memory | yes | yes |
03 | Final control diagnosis | yes | no |
04 | Basic setting | yes → Note | yes → Note → Note |
05 | Clear fault memory | yes | yes |
06 | End output | yes | yes |
08 | Read measured value block | yes | yes |
10 | Adaptation | yes | no |
1) | Necessary after the following operations: Replacement of the engine control unit, or the throttle valve control unit |
2) | This is only possible when the coolant temperature exceeds 80 °C. Until this point, the function is blocked. |
3) | This should be done for the verification and adjustment of ignition timing. |