Leon Mk2
|
A - | Brake pedal switch -F47- |
q | In the footwell zone → Fig. |
B - | Brake light switch -F- |
q | In the footwell zone → Fig. |
C - | Accelerator pedal position sender -G79- |
q | In footwell, accelerator pedal: → Motor Mechanik; Rep. Gr.20 |
D - | Clutch pedal switch -F36- |
q | In the footwell zone → Fig. |
1 - | Throttle valve unit |
q | Dismantling, fitting and checking → Chapter |
2 - | Injector with needle movement sender -G80- |
3 - | Exhaust gas recirculation valve -N18- |
4 - | Throttle valve positioner -V60- |
5 - | Direct diesel injection control unit -J248- |
q | With Altitude sender -F96- |
6 - | Coolant preheating plugs relay -J325- |
q | With Relay for low heating power -J359- |
q | With Relay for high heating power -J360- |
7 - | Connector |
q | For Needle movement sender -G80- |
8 - | Connector |
q | For Engine speed sender -G28- |
9 - | Coolant temperature sender -G62- |
10 - | Connector |
q | For Fuel temperature sender -G81- |
q | For Dosifier -N146- |
q | For Slide travel sender -G149- |
q | For Fuel cut-off valve -N109- (only in the case of 10-pin connectors) |
q | For Injection start valve -N108- (only in the case of 10-pin connectors) |
11 - | Connector |
q | Only in the case of 7-pin connectors for the injection pump |
q | For Fuel cut-off valve -N109- |
q | For Injection start valve -N108- |
12 - | Fuel cut-off valve -N109- |
13 - | Fuel measuring system servomechanism of the injector pump |
q | With Fuel temperature sender -G81- |
q | With Dosifier -N146- |
q | With Slide travel sender -G149- |
14 - | Intake air temperature sender -G42- |