SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Checking pre-heating plugs >
< Adapting engine control unit to electronic immobilizer
Leon Mk2
Power unit
SDI diesel injection and preheating system
Ignition system, glow plug system
Checking preheating system
Checking preheating system
Checking preheating system
Special tools and workshop equipment required
t
Manual multimeter -V.A.G 1526 A-
t
Auxiliary measuring set -V.A.G 1594A- or -V.A.G 1594C-
Checking conditions
l
Battery voltage, OK
l
Ignition off
l
Direct diesel injection control unit -J248-, correct
l
Strap fuse for pre-heating elements -S39-, OK
l
All electrical consumers, e.g. lights and rear window heating must be switched off.
Test sequence
–
Switch ignition off.
–
Remove the coolant temperature sender connector
-1-
.
Note!
On removing the connector “engine cold” is simulated. When ignition is connected, the corresponding preheating process will be carried out.
–
Remove the connectors from pre-heating plugs.
–
Connect multimeter -V.A.G 1526A- to measure voltage between a pre-heating plug connnector and vehicle earth.
–
Switch ignition on. It should indicate battery approx. voltage for about 20 seconds.
–
If no voltage is present:
→ Current flow diagrams, Electrical fault finding and Fitting locations
.
Power unit
SDI diesel injection and preheating system
Ignition system, glow plug system
Checking preheating system
Checking pre-heating plugs >
< Adapting engine control unit to electronic immobilizer