–
| Tighten the hexagon screws -1- to a tightening torque of 10 Nm and the Torx screws -2- to 8 Nm. |
–
| Tighten mounting bolt on speed sensor to 10 Nm. |
Checking rotor on rear axle |
–
| Unscrew speed sensor from wheel bearing housing. |
–
| Check that rotor is not damaged or dirty. |
Removing and installing rotor on rear axle |
–
| Hang up brake calliper on body. |
–
| Check that rotor is not damaged or dirty. |
–
| If the rotor is damaged, always remove and replace wheel hub with rotor. |
Install in reverse order. |
–
| Route speed sensor cable as before removal |
–
| Before fitting the sensor, clean the inner surface of the hole and apply solid lubricant paste → Parts catalogue. |
–
| Tighten mounting bolt on speed sensor to 10 Nm. |
|
|
|