Leon Mk2
| Gear change mechanism: general fitting diagram |
Note| Lubricate the support points and contact surfaces with polycarbamide grease → Parts catalogue. |
| The ignition key withdrawal lock is not mechanical, with cable, but electrical. |
| t | Check functioning of the ignition key withdrawal lock control unit → Chapter. |
| 1 - | Selector lever handle |
| q | Removing and fitting → Chapter |
| q | With handle locking sleeve, preventing its extraction |
| 2 - | Cover for the operation mechanism |
| q | With selector range and Tiptronic mode |
| q | Form a whole with the selector lever handle |
| q | With symbols template and printed circuit board |
| q | The printed circuit board may be tested in the “Guided fault location” with the central diagnosis -VAS 5051B- or central diagnosis -VAS 5052- |
| 3 - | Rubber stop for the selector lever |
| q | Tightly inserted into the gear selection mechanism |
| 4 - | Gear selection mechanism (bracket) |
| q | Removing and fitting → Chapter |
| q | With printed circuit board for integrated gear selection mechanism, do not touch |
| q | With integrated Tiptronic switch -F189- and selection lever locking magnet -N110-; these may be checked using the “Fault location guide” with the central diagnosis -VAS 5051B- or central diagnosis -VAS 5052- |
| q | The Tiptronic switch -F189- may only be replaced with a new gear selection mechanism → Chapter |
| q | The Selection lever locking magnet -N110- can only be replaced by a new gear operation mechanism → Chapter |
| 5 - | Insertion spring |
| 6 - | Bolt: 3,5 Nm |
| 7 - | Insertion plate |
| 8 - | Bolt: 3,5 Nm |
| q | 4 units |
| q | To attach the insertion plate to the gear selection mechanism |
| 9 - | Bush bolts |
| q | To attach the selector lever cable to the gear selection mechanism |
| 10 - | Safety plate |
| q | For selector lever cable to bracket |
| q | Always replace |
| 11 - | Cover |
| q | For the gear selection mechanism. |
| q | With gasket attached |
| 12 - | Self locking nut: 9 Nm |
| q | To attach the cover to the gear selection mechanism |
| q | 4 units |
| q | Always replace |
| 13 - | Selector lever cable |
| q | Do not bend or twist |
| q | Replace the gear selection cable if the protective sheath is damaged |
| q | Checking and adjusting → Chapter |
| q | Removing and fitting → Chapter |
| q | Do not grease the shaft ring or ball socket |
| 14 - | Nut, 13 Nm |
| q | To fix the bracket → Item to the gearbox |
| q | 2 units |
| 15 - | Support |
| q | For the selector lever cable |
| 16 - | Bolt 23 Nm |
| q | To fix the counter support to the gearbox |
| q | 2 units |
| 17 - | Counter support |
| q | For the selector lever cable in the gearbox |
| 18 - | Nut, 10 Nm |
| q | 4 units |
| q | For the gear selection mechanism attached to the bodywork |
