Leon Mk2
| Overview - battery, transmitter/receiver unit, fuse and cable harness |
| 1 - | Positive connection |
| q | Red cable with appropriate connection. |
| 2 - | To terminal 15a |
| q | Connection to terminal 15a → Current flow diagrams, Electrical fault finding and Fitting locations. |
| q | Ensure that this cable is protected by a fuse. |
| q | Fuse maximum 15A. |
| 3 - | Aerial earth |
| q | Ensure good earth connection to body. |
| q | Treat fitting location of aerial with appropriate corrosion protection. |
| 4 - | Transmitter/receiver aerial |
| q | Locations ⇒ Table → Chapter. |
| 5 - | Shielded aerial cable |
| q | Cable with coaxial connector. |
| 6 - | Transmitter/receiver unit, telephone or two-way radio unit |
| 7 - | Cable harness |
| q | Positive voltage supply via a red wire with 2.5 mm2 cross section. |
| q | Negative voltage supply via a brown wire with 2.5 mm2 cross section. |
| q | If necessary, black wire with 1.5 mm2 cross section to terminal 15a. |
| 8 - | Fuse holder |
| q | Install in immediate vicinity of battery. |
| 9 - | To starter |
| 10 - | Battery |
| q | Located in front left of engine compartment. |
| 11 - | Negative cable |
| 12 - | Body earth |
