SEAT Workshop Service and Repair Manuals > Leon Mk2 > Vehicle electrics | Electrical system | Lights, lamps, switches outside | Main beams with gas discharge lamps (Bi-xenon) | Vehicle level sender | Removing and installing rear left vehicle level senderG76

Removing and installing rear left vehicle level senderG76

Removing and installing rear left vehicle level sender -G76-

Special tools and workshop equipment required

t	Torque wrench -SAT 8010-

Removing:

–	Disconnect ignition and all electrical loads, and remove ignition key.

–	Unplug electrical connector -arrow-.

–	Undo the 5 fastening bolts -1- and remove the left rear vehicle level sender -G76--2-.

Installing:

Installation is carried out in the reverse order, noting the following:

–	Tighten nuts and bolts to the torques shown.

–	Check the rear left vehicle level sender -G76- → Chapter.

–	Carry out the headlight adjustment → Booklet101.

Note

t	If the vehicle level senders are replaced, the values of the senders must be checked → Chapter and the basic adjustment of headlamps made → Booklet101.

t	If the values of the vehicle level senders are outside the margin of tolerance, the basic headlamp adjustment can not be carried out.

SEAT Workshop Service and Repair Manuals