Headlamp: correcting the assembly position |
Note t
| Remove the front bumper to correct the assembly position of the headlight. |
t
| The figure shows the left headlamp. |
t
| The right headlight assembly position is corrected the same way. |
If during the check of the final installation position it is established that the headlight gaps are uneven with the body then the installation position must be corrected. |
–
| Disconnect ignition and all electrical loads, and remove ignition key. |
–
| Slacken the securing screws -2- (3,5 Nm) from the top of the headlight. |
|
|
|