seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Main beam light bulb: replacing|Installation > < Main beam light bulb: replacing
Removal:
Removal:
–  Switch off ignition and remove key.
–  Turn light switch to „0“ position.
   
Left headlamp - 1.6 litre 2-valve engine
–  Disconnect hoses -1- and -2- from air cleaner housing.
–  Unscrew the bolt -3-.
–  Take out air cleaner housing.
  A10-1570
Left headlamp - 2.0 litre FSI engine:
–  Remove connector -4- for intake air temperature sender -G42- in air filter housing.
–  Disconnect hoses -1- and -2- from air cleaner housing.
–  Unscrew the bolt -3-.
–  Take out air cleaner housing.
  A27-0203
Left headlamp - 2.0 litre TDI engine:
–  Unplug connector -2- at air-mass meter -G70-.
–  Detach vent hose -1- and air ducts -3- and -5-.
–  Screw out bolt -4- and detach air cleaner housing.
  A10-1667
Right headlamp - vehicles with petrol engine:
–  Remove activated charcoal canister system from support with the pipes connected, upwards -arrow- and leave to one side.
  A10-1581
Right headlamp - vehicles with TDI engine:
–  Lift fuel filter out of retainer -arrow- and place it aside (the hoses remain connected).
  A10-1685
Both sides (continued):
  E94-10044
–  Pull on the rubber tab -arrows- and detach housing cover for main beam/parking light from headlight housing.
–  Detach electrical connector -1- of main beam bulb.
–  Disengage spring clip -arrow-
–  Remove the light bulb -2- from its bracket.
  E94-10016

Main beam light bulb: replacing|Installation > < Main beam light bulb: replacing