SEAT Workshop Service and Repair Manuals > Leon Mk2 > Vehicle electrics | Electrical system | Lights, lamps, switches outside | Park assist steering (PAS) | Park assist steering control unitJ791 | Removing and installing park assist steering control unitJ791

Removing and installing park assist steering control unitJ791

Removing and installing park assist steering control unit -J791-

The park assist steering control unit -J791- is located in the driver footwell, above the relay carrier.

Removing:

–	Switch off ignition and all electrical loads, and pull out ignition key.

–	Remove footwell trim on driver side → General body repairs, interior; Rep. gr.68.

–	Remove left air vent from dash panel → General body repairs, interior; Rep. gr.70.

–	Unscrew securing bolt from underneath -arrow- on park assist steering control unit above relay carrier.

–	Release and separate three connectors -arrows- and remove park assist steering control unit -J791--1- from relay carrier.

Installing:

For fitting, the operations are carried out in reverse order to the removal, taking the following into account:

–	Tighten securing bolt of park assist steering control unit -J791- to 1.5 Nm.

SEAT Workshop Service and Repair Manuals