seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Starter motor: removing and fitting > < Removing and installing battery in engine compartment
Removing and installing second battery under front right seat
Removing and installing second battery under front right seat
  Caution
Danger of injury! Observe warning notices and safety regulations → Chapter!
A battery may also be installed under the front right seat of some vehicles, depending on the equipment.
Special tools and workshop equipment required
   
t  Torque wrench -V.A.G 1331-
Removing battery:
–  Disconnect second battery → Chapter.
  W00-0427
–  Remove positive terminal cover -A-.
  N27-10345
–  Disconnect battery positive terminal clamp -2- of second battery.
  N27-10346
–  Remove the securing bolts -arrows- of the battery cover and remove the cover.
  N27-10347
–  Remove securing nuts -arrows- from the battery retaining plate and remove the retaining plate upwards off the second battery.
–  Pull hose off battery for central gas venting.
–  Remove second battery from vehicle.
Installing battery
Installation is carried out in the reverse order. When installing observe the following:
  Warning
A loosely fitted battery creates the following dangers:
t  Shortened service life due to damage from vibration (danger of explosion).
t  The plates in the battery cells will be damaged if the battery is not secured correctly.
t  Damage to battery housing by clamping bracket (possibility of acid leaking, with high consequential costs).
t  Poor crash safety.
–  Tighten securing bolts and nuts to specified torque setting → Chapter.
  N27-10348

Starter motor: removing and fitting > < Removing and installing battery in engine compartment