SEAT Workshop Service and Repair Manuals

2.0l TSI 147 kW vehicles, automatic gearbox 01JB Removal: –  Turn off the ignition and all electricity consumers. –  With the ignition switched off, disconnect battery earth cable → Chapter. –  Raise the vehicle. –  Remove the right front wheel → Running gear; Rep. gr.Gr. 44.

–  Loosen the screws or quick-type locks -1 - and - 2- and remove front noise insulation.

–  Unscrew the screws -1- for right drive shaft heat shield.

–  Unscrew the bolt -1- from the starter -2- .

–  Unscrew the bolt -1- from the starter -2- .

–  Unscrew the nut -1- and remove the electric cables. –  Unscrew the nut -2- for the clamp.

–  Swivel the starter motor downwards and remove from the vehicle. –  Unplug the electrical connector -1-.

–  Unscrew bolt -1- and remove air conditioning line to facilitate removal of the starter motor. –  Remove starter motor. Installation Installation is carried out in reverse order, noting the following: –  Connect battery. Steps required → Anchor. Tightening torques

Components:	Nm
Starter motor to gearbox	65
Terminal B+ to starter	16
Drive shaft heat shield to gearbox	23