seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing spray jet pop-up cylinders > < Assembly overview - headlight washer system

Leon Mk2

Removing and installing headlight washer system pumpV11
Removing and installing headlight washer system pump -V11-
The headlight washer system pump -V11- is mounted on the washer fluid reservoir in the right-hand wheel housing.
  Note
Depending on equipment, the location of the headlight washer system pump -V11- may deviate slightly from the illustration. Removal procedure is analogue.
Removing:
–  Switch off ignition and all electrical loads, and pull out ignition key.
–  Remove front left wheel housing liner → General body repairs, exterior; Rep. gr.66.
   
–  Follow route of wiring connector -1- and unclip from reservoir.
–  To release, twist securing clip on hose connection -3- and pull off elbow connector from headlight washer system pump -V11--2-.
–  Collect escaping fluid in a suitable container.
–  Pull headlight washer system pump -V11--2- upwards out of rubber seal in reservoir and release and separate connector -1-.
Installing:
For fitting, the operations are carried out in reverse order to the removal, taking the following into account:
–  On completion of installation work, bleed headlight washer system → Chapter.
  N92-10562

Removing and installing spray jet pop-up cylinders > < Assembly overview - headlight washer system