The measurements for adjusting the park position of the wiper blades are made at the ends of the wiper blades. |
The dimensions -A- are measured from the top edge of the cowl panel grille: |
A - | 16 mm, tolerance +10 mm |
B - | 64 mm, tolerance +10 mm |
C - | 19 mm, tolerance +10 mm |
D - | 56 mm, tolerance +10 mm |
–
| Remove wiper arm if necessary and adjust according to the above specified dimensions. |
–
| Tighten threaded connections to specified torque settings → Chapter. |
|
|
|