seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Renewing data bus diagnostic interfaceJ533 > < Renewing data bus diagnostic interfaceJ533

Leon Mk2

Removing and installing data bus diagnostic interfaceJ533
Removing and installing data bus diagnostic interface -J533-
The data bus diagnostic interface -J533- is located in the driver footwell, on the right, next to the steering column.
Removing:
  Note
If the data bus diagnostic interface -J533- is to be replaced, it is essential that the procedure for replacing the „data bus diagnostic interface“ is carried out, so that the codes stored in the unit can be read → Chapter.
–  Switch off ignition and all electrical loads, and pull out ignition key.
–  Remove trim in driver footwell → General body repairs, interior; Rep. gr.68.
–  Remove driver side footwell vent → Heating, ventilation, air conditioning system; Rep. gr.80.
   
–  Release connector -1- and pull it off data bus diagnostic interface -J533--2-.
–  Press securing pins -3- together -arrows- and remove data bus diagnostic interface -J533- from holes.
–  Remove data bus diagnostic interface -J533- from vehicle.
Installing:
Installation is carried out in reverse order.
  N97-10088

Renewing data bus diagnostic interfaceJ533 > < Renewing data bus diagnostic interfaceJ533