SEAT Workshop Service and Repair Manuals

Removing and installing the main fuse box (version 2) Special tools and workshop equipment required

t  Torque wrenches -SAT 8010-

Removing: –  Release the cover -2- with the grip -arrow- from the lock clips -1-. –  Lift the cover -2- of the main fuse box.

–  Remove the side tabs -3- of the cover -2- from the main fuse box -1- and remove cover -2-. –  Disconnect ground lead and the positive terminal from the battery → Chapter.

–  Unscrew the nut -3- of cable B+ -4- and remove cable B+ -4-. –  Place the main fuse box -2-, without fitting it, on the battery -1-.

–  Unclip the tabs -arrows- and remove the cover -1- of the main fuse box -2-.

–  Unscrew the nuts -1- and remove the strip fuses -2-.

–  Unclip the tabs -arrow- and remove the fuse holder -1- of the main fuse box -2-.

–  Move the cable guide -1- in the -direction of the arrow- out of the main fuse box -2- and place it to one side as far as the cables allow. –  Remove the main fuse box -2- of the battery. Installing: Installation is carried out in the reverse sequence; note the following: –  Tighten nuts and bolts to the torques shown. → Chapter