Before beginning with the assembly work, the following sequences must be carried out:
–
Disconnect ignition and all electrical loads, and remove ignition key.
Special tools and workshop equipment required
t
Front-end hooks - 3370-
–
Open the monitor housing in the ceiling.
–
Insert the hook for the front - 3370- between the monitor and the ceiling console hatch and move it in the -direction indicated by arrow A- downwards, until it is supported on the plastic protrusion of the monitor.
–
Carefully remove the monitor with the hook for the front - 3370- in the -direction indicated by arrow B- until the plastic protrusion disengages.
Hold the control for the screen with free hand. This relieves the load on the mount when pulling, preventing deformation or breakage to the console mount and screen.
The illustration shows the monitor with the plastic protrusion disengaged -arrow-:
–
Repeat the same process with the plastic protrusion on the other side of the monitor.
–
Tilt the monitor in such a way that the guides may be extracted -arrows- from the rails.
–
Remove the monitor as much as the length of the cable connection will allow. Now you should be able to see the connector behind the monitor -arrow-.
–
Press the connector block -arrows- and disengage it.