Leon Mk2
Overview of battery, transmitter and receiver unit, fuse and wiring harness |
1 - | Positive connection |
q | Red wire with appropriate connection |
2 - | To terminal 15a |
q | Connection to terminal 15a: → Current flow diagrams, Electrical fault finding and Fitting locations |
q | Ensure that wiring is protected. |
q | Fuse max. 15A |
3 - | Aerial earth |
q | Ensure good earth connection to body. |
q | The aerial location of installation must be adequately protected from rust |
4 - | Transmitter and receiver aerial |
q | Installation location: ⇒ Table page → Chapter |
5 - | Screened aerial wire |
q | Cable with coaxial connector |
6 - | Transmitter and receiver unit, telephone or two-way radio unit |
7 - | Wiring harness |
q | Voltage supply (positive) via a red cable of 2.5 mm 2 cross-section. |
q | Voltage supply (negative) via a brown cable of 2.5 mm 2 cross-section. |
q | If necessary, black cable of 1.5 mm2 cross-section to terminal 15a |
8 - | Fuse holder |
q | Fit in immediate vicinity of battery |
9 - | To starter |
10 - | Battery |
q | Installation location: In engine compartment |
11 - | Negative wire |
12 - | Body earth |