SEAT Workshop Service and Repair Manuals > Leon Mk2 > Vehicle electrics | Vehicle electrics | Starter-current supply-CC | Alternator | Removing and installing voltage regulator | Voltage regulator, removing and installing; manufacturer: Valeo

Voltage regulator, removing and installing; manufacturer: Valeo

Special tools and workshop equipment required

t	Torque wrench -V.A.G 1783/-

Removing:

–	Remove alternator → Chapter.

–	Remove clamping rings -arrows- and remove protective cap from alternator.

–	Unscrew securing bolts of voltage regulator -arrows- (2 Nm).

–	Remove voltage regulator from alternator.

Installing:

Install in the same way but in reverse order of removal. When doing this, note the following:

–	Remove locking lugs -arrows- and pull protective cap off voltage regulator.

–	Push carbon brushes into housing of voltage regulator and insert voltage regulator into alternator.

–	Tighten threaded connections to specified torques.

–	Voltage regulator to alternator 2 Nm.

–	Protective cap to alternator 4.5 Nm.

–	Push protective cap into guides -arrows- until it can be heard to engage.

SEAT Workshop Service and Repair Manuals