SEAT Workshop Service and Repair Manuals

Removing and installing relay and fuse holder in E-box The fuse holder in the E-box is attach to the side of the E-box on the battery. Special tools and workshop equipment required

t  Torque wrench -V.A.G 1410-

t  Release tool set -VAS 1978/35-   Caution To disconnect and reconnect the battery, the procedure described in the workshop manual should be strictly adhered to → Chapter. Removing: –  Switch off ignition and all electrical consumers, and remove ignition key. –  Disconnect battery . → Chapter –  Remove E-box on battery → Chapter.   Caution t  Electrical components protected by the multiple fuse can fail! t  When the nuts for the wiring connections are undone, the multiple fuse will be damaged! t  The multiple fuse must be renewed after any loosening of the connections!

–  Undo and remove the 2 nuts -arrows- and remove electroconductive plate -1- and multiple fuse -2- from E-box.

–  Turn E-box over, release locking lug -arrow- and pull fuse holder -1- upwards off the E-box.

–  Press catches at sides -arrows- and remove lid of fuse holder -1-. –  Make a note of the fuse assignment and remove all fuses from the fuse carrier.

–  Pull primary locking element -1- in -direction of arrow-, release all plug-in contacts with the correct release tool from the release tool set -VAS 1978/35- and then pull downwards out of the fuse holder.   Note The assignment of the correct release tool is shown in the table in the → operating instructions for the VAS 1978/35 Installing: Install in the same way but in reverse order of removal. When doing this, note the following:

–  Insert a new multiple fuse -2- and tighten nuts -arrows- to 6 Nm. –  Connecting battery → Chapter.