skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing driver airbag unit 08.04 ? > < Replacing parts of the airbag system

Fabia Mk1

Removing and installing driver airbag unit ? 07.04
Removing and installing driver airbag unit ? 07.04
  WARNING
Safety regulations should be observed when handling the airbag units → Chapter.
  Note
Additional operations should be carried out after the battery earth strap has been disconnected and connected → Electrical System; Rep. Gr.27.
Removing
   
–  Turn steering wheel until one of the holes -arrows A- is located at the top.
–  Using a small screwdriver, unhook the spring -arrow B- from the rear of the steering wheel (through the hole).
–  Repeat process for the second spring.
–  Carefully remove airbag unit from the steering wheel and fold back.
  S69-0113
–  Disconnect connector -arrow- from the airbag unit.
–  Lay aside the airbag unit in such a way that the impact absorber points upwards.
Install
–  Installation is carried out in the reverse order.
–  Switch on ignition.
–  Connect earth cable of the battery.
  WARNING
Nobody should be in the vehicle when the battery is being connected.
  S69-0114

Removing and installing driver airbag unit 08.04 ? > < Replacing parts of the airbag system