skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Brakes, hydraulics, regulator, servo > < Removing and installing the foot controls - RHD version

Fabia Mk1

Removing and installing the brake pedal - RHD version
Removing and installing the brake pedal - RHD version
Special tools and workshop equipment required
t  Vehicle system tester -V.A.G 1552- or vehicle diagnosis, measurement and information system -VAS 505x-
t  Release tool -T10159A-
t  Internal extractor (10.0...14.0 mm) -Kukko 21/02-
t  Polycarbamide grease -G 052142 A2-
Removing:
  Note
Before disconnecting the battery determine the code of radio sets fitted with anti-theft coding.
–  Disconnect battery → Electrical System; Rep. gr.27.
–  Removing the lower part of the dash panel → Body Work; Rep. gr.70.
Vehicles without air conditioning
–  Remove right footwell vent → Heating, Air Conditioning; Rep. gr.80.
Vehicles with air conditioning
–  Remove right footwell vent → Heating, Air Conditioning; Rep. gr.87.
Continued for all vehicles
–  Remove brake light switch → Chapter.
–  Pull out plug of accelerator pedal position sender -G79-.
–  Separating the brake pedal from the brake servo unit → Chapter.
   
–  Unscrew nut -arrow-.
  Note
In the fig. the nut is covered by the bearing bracket.
–  Release screw for bearing bolt -1-.
–  Remove brake pedal -2-.
  S46-0117
–  Pull bearing bolt -1- out of the casing tube -3- of the brake pedal.
  Note
Replace all removed bushings.
–  Insert and tension interior extractor -Kukko 21/02- on the bushing -2-.
–  Pull out bushing by hand from the casing tube.
Installing:
Installation is carried out in the reverse order.
  Note
Do not tilt bushings when installing.
–  Insert new bushings in the brake pedal if they were removed.
   Press in bushings up to stop.
–  Grease bearing points of the brake pedal (bearing bolts and bushings) with polycarbamide grease -G 052 142 A2-.
–  Setting and installing the brake light switch → Chapter
–  Perform automatic test sequence → Chapter using the vehicle system tester -V.A.G 1552- or the vehicle system test → Vehicle diagnostic, testing and information system VAS 5051 using the vehicle diagnosis, measurement and information system -VAS 505x-.
  S46-0118
Tightening torque:
Brake pedal to bracket
t  Use new nuts!
25 Nm

   

Brakes, hydraulics, regulator, servo > < Removing and installing the foot controls - RHD version