skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

Disassembling and assembling intake manifold > < Installed location overview for engines with engine identification characters BBY, BBZ, BKY
Fitting locations for engine with identification characters BUS - Overview
   
Fitting locations for engine with identification characters BUS - Overview
The components marked with A and B are not shown in the fig.
A - Accelerator pedal position sender -G79- and accelerator pedal position sender 2 -G185-*
q   in footwell on the accelerator pedal (both senders integrated into a housing)
B - Lambda probe downstream of catalytic converter -G130-*
q   downstream of main catalytic converter
1 - Electric heated vacuum regulating valve (PCV valve)
q   at oil scraper → 1.4/55; 1.4/59; 1.4/74 Engine - Mechanics → Rep. Gr.17
2 - Injectors - (N30…N33)-*
q   at fuel distributor
q   removing and installing → Chapter
3 - Intake manifold pressure sender -G71-* with intake air temperature sender -G42-*
q   on the intake manifold → Item
4 - Knock sensor 1 -G61-*
q   at rear cylinder block
q   removing and installing → Chapter
5 - Activated charcoal filter system solenoid valve 1 -N80-*/**
q   on the intake manifold → Item
6 - Throttle valve control unit -J338-*/ **
q   with throttle valve drive (electronic power control) -G186 (V60) -, angle sensor for throttle valve drive -G187- and angle sensor 2 for throttle valve drive -G188-
q   on the intake manifold → Item
7 - Engine speed sender -G28-*
q   at rear crankshaft sealing flange, on the suction side
q   Check engine speed sender -G28-, remove and install → Chapter
8 - Hall sender -G40-*
q   on camshaft housing → Chapter
9 - Coolant temperature sender -G62-*
q   in coolant regulator housing
10 - Engine control unit -J623- with ambient pressure sender*
q   replace → Chapter
q   Coding → Chapter
q   Adaptation → Chapter
11 - Thermoswitch for radiator fan -F18-
q   at bottom left coolant fitting
12 - 4-pin connector
q   for lambda probe -G39- and lambda probe heating before catalyst
q   at plug holder at starter
13 - Lambda probe upstream of catalytic converter -G39-*
q   at exhaust manifold
14 - Ignition coils with a power output stage -N70, N127, N291, N292-*
q   removing and installing → Chapter

   

Disassembling and assembling intake manifold > < Installed location overview for engines with engine identification characters BBY, BBZ, BKY