Fabia Mk1
Installed location overview for engines with the engine identification characters AUA, AUB |
1 - | Activated charcoal filter system solenoid valve 1 -N80-*/** |
q | check → Chapter |
2 - | 3-pin plug connection |
q | for engine speed sender -G28- |
3 - | Intake manifold pressure sender -G71-* with intake air temperature sender -G72-* |
4 - | Intake manifold |
5 - | Injector - (N30…N33)-* |
6 - | Knock sensor -G61-* |
q | Fitting location: cylinder block suction side |
q | check → Chapter |
7 - | Engine control unit * |
8 - | Throttle valve control unit -J338-* |
q | with throttle valve drive (electronic power control) -V60-, angle sensor for throttle valve drive -G187- and angle sensor 2 for throttle valve drive -G188- |
9 - | Engine speed sender -G28-* |
q | inductive pickup |
q | Fitting location: cylinder block suction side |
q | Check engine speed sender -G28-, remove and install → Chapter |
10 - | Ignition transformer -N152-* |
q | with identification for ignition leads, do not switch |
q | check → Chapter |
11 - | 6-pin plug connection |
q | for wide band lambda probe with lambda probe heating before catalyst |
12 - | Exhaust gas recirculation valve -N18-*/ ** with exhaust gas recirculation potentiometer -G212-* → 1.4/55; 1.4/59; 1.4/74 Engine - Mechanics → Rep. Gr.26 |
13 - | Sender for coolant temperature -G62-* |
q | check → Chapter |
14 - | Hall sender - G40-* |
q | check → Chapter |
15 - | Lambda probe 1 downstream of catalytic converter -G39-*, 50 Nm |
q | Fitting location: in the exhaust manifold |
q | 6-pin plug connection |
16 - | Lambda probe 2 after catalytic converter -G130-*, 50 Nm |
q | Fitting location: downstream of catalytic converter |
q | 4-pin plug connection |