Fabia Mk1
Summary of components of air conditioning unit |
1 - | Fresh air blower series resistor -N24- |
q | removing and installing → Chapter |
2 - | Fresh air flap and re-circulating air flap control motor -V154- |
q | with installed potentiometer -G143 - |
q | removing and installing → Chapter |
q | check → Chapter |
3 - | Fresh air blower -V2- |
q | removing and installing → Chapter |
4 - | Dust and pollen filter |
q | also as combination filter with odour filter |
q | removing and installing → Chapter |
5 - | Flex shaft |
q | for positioning unit for air distribution flaps |
Colour: blue - 250 mm long |
q | removing and installing → Chapter |
6 - | Control for heating and air conditioning system |
q | Summary of components → Chapter |
q | must be replaced completely |
q | removing and installing → Chapter |
7 - | Plug for footwell vent temperature sender -G192- |
8 - | Footwell vent temperature sender -G192- |
q | to disassemble, remove dash panel, turn sender 90° to the left |
q | check → Chapter |
9 - | O-ring |
q | replace if damaged |
10 - | Heating element for additional air heating (PTC) -Z35- |
q | only fitted on certain models |
q | Summary of components → Chapter |
q | removing and installing → Chapter |
11 - | Heat exchanger |
q | Summary of components → Chapter |
q | removing and installing → Chapter |
12 - | Control motor for temperature flap -V68- |
q | with installed potentiometer -G92 - |
q | removing and installing → Chapter |
q | check → Chapter |
13 - | Gasket with holder |
q | clipped into heater unit |
q | replace if damaged |
q | Fitting position → Fig. |
14 - | Valve for condensation water drain |
q | mount together with holder → Item on air conditioning unit |
15 - | Plug for evaporator vent temperature sender -G263- |
16 - | Middle vent temperature sender -G191- |
q | installed in the intermediate piece for dash panel vents |
q | to disassemble, remove dash panel and intermediate piece, turn sender 90° to the left |
q | check → Chapter |
17 - | Evaporator vent temperature sender -G263- |
q | to disassemble, remove dash panel, pull out sideways |
q | check → Chapter |
18 - | Sealing ring |
q | replace if damaged |
19 - | Supports |
q | for cooling the storage tray in the glove compartment |
q | screwed onto housing |
20 - | Connecting hose |
q | to the storage tray in the glove compartment |