–
| Position extractor -T10052- align them with the hub bores. |
–
| Screw fixing screws -1- into the hub. |
–
| Put the hub under tension by uniformly tightening the central bolt -2- until the hub is released from the camshaft cone. |
Note Hold the extractor firmly using an open-end wrench. |
–
| Remove hub from cone of camshaft. |
–
| Remove cylinder head cover. |
–
| Remove valve-lever shaft. |
Note First release crosswise the two outer and then both inner fixing screws. |
–
| First remove bearing caps 2 and 3. Release bearing caps 1 and 4 alternately and crosswise. |
Note Bearing cap 4 is identified like bearing cap 5. |
|
|
|