Fabia Mk1
Removing and installing sealing flange and flywheel |
Note
t | Maintenance of clutch → gearbox; Rep. gr.30. |
t | Secure the engine with engine mount -MP1-202- and distance sleeves -T30010- on the assembly stand before performing assembly work. |
1 - | Cylinder block |
q | removing and installing crankshaft → Chapter |
q | Disassembling and assembling pistons and conrods → Chapter |
2 - | 60 Nm + torque a further 90° (1/4 turn) |
q | replace |
3 - | Flywheel |
q | Assembly only possible in one position - holes offset |
q | for removing and installing the flywheel lock with -MP1-504- → Fig. |
4 - | Intermediate plate |
q | do not damage/bend during assembly work |
q | hang on the sealing flange → Fig. |
q | must be positioned on dowel sleeves |
5 - | 15 Nm |
6 - | Sealing flange on flywheel side |
q | to remove and install, take off oil pan → Chapter |
q | must be replaced completely |
q | only install sealing flange with PTFE gasket ring (pay attention to different versions → Fig.) |
q | install gasket ring dry, the crankshaft stub must be free of grease |
q | install new sealing flange with guide sleeve (do not pull guide sleeve off the seal before installing) |
7 - | PTFE gasket ring |
q | replace → Chapter |
q | only install PTFE gasket ring (pay attention to different versions → Fig.) |
8 - | Sealing flange on the belt pulley side |
q | must be positioned on dowel sleeves |
q | removing and installing → Chapter |
|
I | Elastomer gasket ring 1 sealing lip -1-; with garter spring |
II | PTFE gasket ring multiple sealing lips -2-; without garter spring |
Note
|
|
|