skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Front wing > < Overview of noise insulation assembly

Fabia Mk2

Trim panels for the vehicle floor
Trim panels for the vehicle floor
Overview of vehicle floor covers.
   
Removing:
–  Remove nuts -2- (2 Nm).
–  Remove vehicle floor cover -1- or -3- (left or right).
Installing:
–  Installation is carried out in the reverse order.
  A50-0741
Tunnel-heat shield
Removing:
–  Remove vehicle floor cover on left and right → Anchor.
–  Remove tunnel bridge → Anchor.
–  Loosen fixing nuts for front exhaust pipe hanger → Engine → Rep. gr.26.
–  Loosen screws for rear exhaust pipe hanger → Engine → Rep. gr.26.
–  Separate the exhaust pipe and unhook downwards → Anchor → Engine → Rep. gr.26.
–  Slacken nuts -2- (1.5 Nm) and remove heat shield -1- from the bolt -3-.
Installation is carried out in the reverse order.
  A50-0740
Tunnel bridge
Removing:
–  Remove nuts -arrows- (20 Nm) and remove tunnel bridge.
–  If the exhaust pipe must be removed, slacken the screws on the double clamp -1- → Engine → Rep. gr.26.
Installing:
–  Installation is carried out in the reverse order.
  S34-1065
Heat shield cover - middle
Removing:
–  Remove screws for support of fixing belt for fuel tank → Engine → Rep. gr.20.
–  Remove screw for rear exhaust pipe hanger → Engine → Rep. gr.26.
–  Unhook exhaust pipe as far as possible downwards → Engine → Rep. gr.26.
–  Remove circlips -1- (F = 1.5 Nm).
–  Remove heat shield cover -2-.
Installing:
–  Installation is carried out in the reverse order.
  S50-0313
Heat shield cover - rear
Removing:
–  Remove screw -3- for rear exhaust pipe hanger -2- → Engine → Rep. gr.26.
–  Unhook exhaust pipe as far as possible downwards → Engine → Rep. gr.26.
–  Remove screws -5- (23 Nm).
–  Remove circlips -4- (F = 1.5 Nm).
–  Remove cover.
Installing:
–  Installation is carried out in the reverse order. Replace circlips -4- with new ones if damaged.
  S50-0308

Front wing > < Overview of noise insulation assembly