skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the camshaft sprocket, setting the timing > < Removing and installing the camshaft sprocket, setting the timing

Fabia Mk2

Inspect setting of the timing
Inspect setting of the timing
Special tools and workshop equipment required
t  Pipe section - T10123-
t  Assembly device -T10121-
  Note
t  The crankshaft is at TDC of the piston for cylinder 1 for mixture ignition only then when the camshaft is standing atTDC of the piston for cylinder 1 (both devices must be interlocked).
t  The assembly device -T10121- also serve at the same time as a fixing lever to loosen and tighten up the crankshaft screws.
t  The engine can be easily turned once the spark plugs have been removed.
–  If necessary remove engine cover with air filter → Chapter.
   
–  Remove caps at cylinder head cover -arrows-.
–  Remove engine speed sender -G28- on the cylinder block.
–  Remove covers for camshafts.
  S13-0518
–  Pipe sections -T10123- must be lightly pushed into the camshafts.
–  Fasten both devices with screws (M6).
  S13-0519
–  Interlock crankshaft, press the assembly device -T10121- into the hole in the flywheel.
  Note
If the assembly device -T10121- cannot be inserted, remove the pipe sections -T10123- out of the camshafts. Rotate crankshaft in direction of rotation of engine (360°) and repeat the procedure.
If both devices cannot be inserted:
–  Setting the timing → Chapter.
If both devices can be inserted:
–  Remove the devices from the holes and install caps as well as engine speed sender.
Further installation occurs in reverse order.
  S13-0354

Removing and installing the camshaft sprocket, setting the timing > < Removing and installing the camshaft sprocket, setting the timing