skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Summary of components of air conditioning unit > < Summary of components for heating and air conditioning system control

Fabia Mk2

Removing and fitting the heating and air conditioning system control
Removing and fitting the heating and air conditioning system control
–  Take out the ignition key and switch off all electrical components.
   
–  Slightly press the cover -arrow A- and slacken the cover at the top and at the bottom catch using a small screwdriver or a disassembly wedge -3409--arrow B-. Slacken the cover on the right side of the heater control in the same way.
  S96-0159
–  Removing centre part dash panel -5- → Body work; Rep. gr.70.
–  Carefully press off the trim -4- at the heater control -3-. It is clipped.
–  Release screws -6- (1 Nm).
–  Removing flex shaft -2- for positioning unit of air distribution flaps.
  S80-0164
To remove the plastic part, press the flex shaft -arrow- and pull out of the control -1-.
–  Vehicles as of CW 46.2010 - detach the flex shaft from the temperature flap positioning unit control in the same way.
–  Slightly press together the catches in the corners and push out the heater control.
–  Disconnect plug.
Installation is carried out in the reverse order. Pay attention to the following:
t  The flex shaft can only be installed in one way on the heater control see → Anchor.
t  If the heating and air conditioning unit control was replaced, perform a basic setting → Vehicle diagnostic, testing and information system VAS 5051
  S80-0152

Summary of components of air conditioning unit > < Summary of components for heating and air conditioning system control