| Running-in instructions for the compressor |
| After the initial filling of the refrigerant circuit or after flushing/blowing through the refrigerant circuit, the whole volume of refrigerant oil is in the compressor. |
| To avoid damaging the compressor, the compressor must be loaded as follows: |
| –
| Position the rotary switch for air distribution on „person flow“. |
| –
| Open all dash panel vents. |
| –
| Position the fresh-air blower switch at least on speed 3. |
| –
| Position rotary switch for temperature selection on the left stop (minimum temperature). |
| –
| Switch on air condition system once idle stabilisation has been achieved (after approx. 5 seconds). |
| –
| Run engine without interruption for at least 2 minutes at idle speed. |
|
| Maximum engine speed: 1500 rpm1. |
| –
| Subsequently switch off engine. |
| This shuts off the oil distribution in the refrigerant circuit and the compressor can be fully loaded. |
|
|
|
