Installing sealing flange with rotor |
Note t
| The sealing flange with PTFE gasket ring is provided with sealing lip supporting ring. This supporting ring is intended as an assembly sleeve and must not be removed before installing. |
t
| Do not separate or turn to each other the sealing flange and rotor after removing them from the spare part package. |
t
| The rotor is given its fitting location by positioning the assembly device -T10017- or - T10134- onto the positioning pin. |
t
| The rotor has an elastomer layer on its sealing surface with the crankshaft. This layer must not be brought into contact with dirt or grease. |
t
| The sealing flange and gasket ring form one unit and must be replaced together with the rotor. |
t
| The fitting location of the assembly device -T10017-, or -T10134- to the crankshaft is determined by means of a guide bolt, which is guided through the threaded bore of the crankshaft. |
t
| Unless otherwise indicated, the method for the assembly device -T10017- and -T10134- is identical. |
Assembly device -T10017- or -T10134- |
|
|
|