skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Install cylinder head cover > < Remove cylinder head cover

Fabia Mk2

Removing and installing camshaft
Removing and installing camshaft
Removing
–  Remove fixing bolt -T10414-.
–  Place the cylinder head cover on the work bench as shown.
   
–  Release the fixing screws for the bearing frame in the specified order -1- to -10-.
–  Remove bearing frame.
  M15-10004
–  Lift the camshaft -1- out of the cylinder head cover -2-.
Install
  Note
Before fitting, moisten the camshaft and the camshaft bearings lightly with engine oil.
–  Place the camshaft -1- in the cylinder head cover -2-.
  N15-10565
–  Insert the fixing bolt -T10414 - into the nuts of the camshaft and tighten the screw by hand.
–  Position the bearing frame onto the bearing surfaces of the camshaft.
The bearing frame is put into the correct position by means of the centering pins -arrows-.
  N15-10566
–  Tighten the fixing screws to 8 Nm in the specified order -1- to -10-.
Install cylinder head cover → Chapter.
  M15-10005

Install cylinder head cover > < Remove cylinder head cover