Fabia Mk2
| V-ribbed belt drive - Summary of components |
| 1 - | Tensioning pulley for ribbed V-belt |
| q | Swing out the tensioning pulley with a ring spanner |
| q | the tensioning pulley can be secured by inserting the 4 mm hexagon socket wrench into the fit hole |
| 2 - | Bracket for auxiliary units |
| 3 - | 50 Nm |
| q | Tightening sequence: tighten first top right bolt, then bottom right bolt, and last the bolts at the left (looking in direction of travel) |
| 4 - | 23 Nm |
| 5 - | AC generator |
| q | removing and installing → Electrical System → Rep. gr.27 |
| q | to facilitate the positioning of the generator, drive the threaded bushings for fixing screws at the generator slightly backwards |
| 6 - | 20 Nm + torque a further 1/4 turn (90°) |
| 7 - | Bushing |
| q | 2 pieces |
| 8 - | 25 Nm |
| 9 - | AC compressor |
| q | removing and installing → Heating, Air Conditioning → Rep. gr.87 |
| 10 - | V-ribbed belt |
| q | mark the direction of rotation with chalk or a felt-tip pen before removing |
| q | check for wear |
| q | removing and installing → Chapter |
| q | Routing of the ribbed V-belt → Chapter |
| 11 - | Belt pulley |
| q | for the V-ribbed belt |
| 12 - | 150 Nm + torque a further 1/2 turn (180°) |
| q | replace |
| q | The contact surfaces of the fixing screw and the belt pulley must be free of grease and oil |
| q | Oil the thread of the screw |
| q | Counterhold belt pulley with counterholder -T30004 (3415)- with bolt -T30004/1 (3415/1)- |
| q | tightening may occur in successive stages |
| q | the torquing angle can be measured with a commercially available angle measuring plate, e.g. -Hazet 6690- |
|
|
