skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Replacing gasket ring for crankshaft -on the belt pulley side- > < Removing and installing cylinder block

Fabia Mk2

Cylinder block made out of aluminium - summary of components
Cylinder block made out of aluminium - summary of components
  WARNING
The crankshaft must not be removed. Merely releasing the screws for the crankshaft bearing cover will result in deformations of the bearing seats of the cylinder block. These deformations reduce the bearing clearance. Even if the bearing shells were not replaced, the changed bearing clearance may cause damage to the bearing.
If the bearing cover screws have been released, replace the complete cylinder block together with the crankshaft.
It is not possible to measure the crankshaft bearing clearance under workshop conditions.
  Note
Repairing clutch → Manual gearbox; Rep. gr.30
   
1 - 10 Nm
2 - Intake manifold
q   Clean strainer if dirty
3 - Cylinder block
4 - Knock sensor
5 - 20 Nm
q   the tightening torque influences the knock sensor function
6 - 60 Nm + torque a further 1/4 turn (90°)
q   replace
7 - Flywheel
q   For removing and installing the flywheel, secure with -MP1-223 (3067)-
8 - Intermediate plate
q   must be positioned on dowel sleeves
q   do not damage/bend during assembly work
9 - 12 Nm
q   replace
10 - Sealing flange on the gearbox side
q   with rotor and gasket ring
q   always replace complete with gasket ring and rotor
q   removing and installing → Chapter
11 - Engine speed sender -G28-
12 - 5 Nm
13 - Gasket
q   replace
14 - Oil pump
q   must be replaced completely
q   when fitting pay attention to the driver on the crankshaft -Pos. 16-
q   must be positioned on dowel sleeves
q   removing and installing → Chapter
15 - Sealing ring
q   replace → Chapter
16 - Driver
q   coat with oil before installing the oil pump

   

Replacing gasket ring for crankshaft -on the belt pulley side- > < Removing and installing cylinder block