skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing front passenger airbag key switch > < Removing and installing passenger airbag unit

Octavia Mk1

Removing and installing the side airbag crash sensor
Removing and installing the side airbag crash sensor
Removing:
–  Disconnect earth strap of the battery.
–  Remove front seat → Chapter.
–  Remove the entrance plate → Chapter.
–  Roll up carpet at the front of the B-cross member.
   
–  Disconnect plug connection -1-.
–  Release screws -2- of the crash sensor -3-.
   Tightening torque = 9 Nm.
Install
Installation is carried out in the reverse order.
t  Switch on the ignition before connecting the battery.
  WARNING
Nobody should be in the vehicle when the battery is being connected.
  Note
If the battery earth strap is disconnected and re-connected, carry out additional operations → Electrical System → Rep. gr.27.
  S69-0074

Removing and installing front passenger airbag key switch > < Removing and installing passenger airbag unit