Skoda Workshop Service and Repair Manuals > Octavia Mk1 > Body | Body Work | Seat frames | Rear seats | Removing and installing seat bench and backrest (separated)

Removing and installing seat bench and backrest (separated)

Remove the seat bench

–	Pull seat bench forwards on the catches -arrows- and fold open.

–	Push out hooks -1- from the seat bench out of the lugs -2- and remove seat bench from the vehicle.

–	Unlock both backrest parts and fold over.

Install

Installation is carried out in the reverse order.

Removing backrest

–	Fold back the rear seat bench.

–	Unlock backrest upwards and fold back.

–	Press in the catch hook -1- with a screwdriver on the left outer side of the backrest (valid for vehicles with non-separated backrest) or on both outer sides of the backrest (valid for vehicles with separated backrest) to the rear.

–	Pull backrest -2- upwards out of the positions -3-.

–	Take out backrest -2- from the middle position -5- or also from the right side bearing (vehicles with non-separated backrest).

Note

It is possible to adapt the position of the lugs -4- for the correct locking of the backrest using a rubber hammer.

Install

Installation is carried out in the reverse order.

Skoda Workshop Service and Repair Manuals