skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the front brake caliper piston > < Repairing the front brake caliper, brake caliper FS - III

Octavia Mk1

Summary of Components of Brake Caliper FS-III
Summary of Components of Brake Caliper FS-III
Special tools and workshop equipment required
t  Piston jig -MP 9-403-
t  Plastic wedge -3409-
t  Brake fluid → Chapter
t  Lithium grease -G 052 150 A2-
  Note
t  Install the complete repair set when undertaklng repairs.
t  The brake calipers must absolutely be pre-bled before installing them in the vehicle (without brake pads) in case of a repair or when replacing them with new brake calipers → Chapter.
t  Thinly coat brake cylinder, piston and gasket ring with lithium grease -G 052 150 A2-
   
1 - Dust cap
2 - Vent valve, 10 Nm
t  thinly coat thread with lithium grease -G 052 150 A2- before screwing in
3 - Bushing
t  insert in brake caliper housing
4 - Guide bolt, 30 Nm
5 - Caps
t  insert in bushing
6 - Brake caliper housing
7 - Sealing ring
t  removing and installing → Chapter
8 - Piston
t  removing and installing → Chapter
t  before installing, thinly coat piston with lithium grease -G 052 150 A2-
9 - Protective cap
t  do not damage when inserting the piston

   

Removing and installing the front brake caliper piston > < Repairing the front brake caliper, brake caliper FS - III