Octavia Mk1
1 - | Brake disc, internally ventilated |
t | Assignment → Electronic Catalogue of Original Parts |
2 - | Wheel screw, 120 Nm |
3 - | 4 Nm |
4 - | Brake disc |
Assignment → Electronic Catalogue of Original Parts |
5 - | Cap |
t | replace after each removal |
t | press off → Fig. and → Fig. |
t | inserting → Fig. |
6 - | Self-locking twelve-point nut 70 Nm +40° |
t | replace after each removal |
7 - | Wheel hub with wheel bearing and pulse rotor |
t | only on vehicles with ABS |
t | The wheel bearing and the wheel hub are fitted together in one housing |
t | this wheel hub/wheel bearing unit is maintenance-free and has no play; it is not possible to undertake any kind of adjustment or repair work on it! |
t | only replace completely after each removal |
t | Remove wheel hub with wheel bearing from axle stud → Fig. |
t | Pull wheel hub with wheel bearing onto axle stud → Fig. and → Fig. |
Note
t | If the inner ring of the bearing remains on the axle stud after pulling off the wheel hub with wheel bearing, the old inner ring of the bearing must be pulled off before pressing on the new wheel hub with wheel bearing → Fig. |
t | The inner ring of the bearing is a component part of the new wheel hub with wheel bearing and is therefore not pressed on separately. |
8 - | Axle body |
t | removing and installing → Chapter |
9 - | Brake caliper |
t | dismantling → Fig. |
10 - | Axle stud |
t | Straightening work is not allowed! |
t | Re-cutting the thread is not allowed. |
|
|
Note
|
|
Note
|
|
|
Note
|
Tightening torques: |
Wheel hub with wheel bearing on axle stud | 70 Nm + 40° |
Securing screw for brake disc | 4 Nm |
Screws for brake caliper | 65 Nm |