Octavia Mk1
Note
|
| 1 - | Top toothed belt guard |
| 2 - | Main drive-toothed belt |
| q | check for wear |
| q | do not kink |
| q | removing and installing, tensioning → Chapter |
| 3 - | Coupling drive-toothed belt |
| q | check for wear |
| q | do not kink |
| q | removing and installing, tensioning → Chapter |
| 4 - | 10 Nm + torque a further 1/4 turn (90 °) |
| q | replace |
| q | tighten from the middle |
| 5 - | Ignition lead guide |
| q | pay attention to different version |
| 6 - | Non-return valve |
| q | from 01.02 |
| 7 - | From air filter |
| 8 - | Camshaft housing |
| q | removing and installing → Chapter |
| q | remove old sealant residues |
| q | coat with agent -D 188 003 A1- before fitting |
| q | when installing, fit onto stud bolts and dowel pins vertically from above. |
| 9 - | 10 Nm |
| 10 - | Fit pin |
| 11 - | Roller rocker arm |
| q | inspect roller bearings for smooth operation |
| q | for installing, clip onto hydraulic supporting element with locking clips |
| q | oil contact surface |
| 12 - | Hydraulic supporting element |
| q | do not interchange |
| q | before installing check axial play of the camshaft → Fig. |
| q | oil contact surface |
| 13 - | Cylinder head bolt |
| q | replace |
| q | pay attention to mounting instructions and order for tightening → Anchor |
| 14 - | Cylinder head gasket |
| q | replace |
| 15 - | Cylinder head |
| q | removing and installing → Chapter |
| q | check for distortion → Fig. |
| q | Clean and de-grease the contact surfaces with the camshaft housing |
| q | after replacing fill entire system with fresh coolant → Chapter |
| 16 - | Coupling drive tensioning pulley |
| q | check → Chapter |
| q | Tensioning toothed belt → Chapter |
| 17 - | 20 Nm |
| 18 - | Rear timing belt guard |
| 19 - | Lifting eye |
|
|
