skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing camshaft > < Replacing camshaft gasket ring|Install

Octavia Mk1

Condition
Condition
l  The pistons must not be positioned at top dead centre.
–  Remove the oil residues on the camshaft with a clean cloth.
  Note
Do not oil sealing lip of the gasket ring.
   
–  Fit on gasket ring with guide sleeve -T10071/1 - and press in fully with insertion sleeve -MP 1-315 - and bolt -T10071/2-.
  Note
Place a larger commercially available M12 washer below the bolt in order to avoid wear to the pressure sleeve.
–  Insert parallel key into camshaft.
  S15-0182
–  Install camshaft sprocket and tighten to 100 Nm (use counterholder -T30004-).
  Note
When rotating the camshaft, the crankshaft must not be positioned at TDC. Risk of damaging valves and piston crowns.
The further assembly is carried out in reverse order to disassembly.
–  Installing timning belt, tensioning (setting timing) → Chapter 13-2.
  S15-0179

Removing and installing camshaft > < Replacing camshaft gasket ring|Install