skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing drive plate > < Replacing gasket ring for crankshaft -on the belt pulley side-

Octavia Mk1

Removing and installing flywheel
Removing and installing flywheel
t  Torque wrench
t  Counterholder -MP 1-222-
Removing
–  Mark installation of the flywheel to the crankshaft e.g. with a waterproof felt pen.
   
–  Remove the flywheel. Lock flywheel with counterholder -MP 1-222 -.
Install
–  Position flywheel on the crankshaft in the position marked before removal.
–  Insert new fixing bolts and tighten by hand.
–  Tighten fixing screws to 60 Nm and torque a further 90° (1/4 turn) (the tightening may occur in several stages).
  S13-0084

Removing and installing drive plate > < Replacing gasket ring for crankshaft -on the belt pulley side-