Skoda Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing pump for Haldex coupling V181 >
< Electric/Electronic components and fitting locations
Octavia Mk1
Power transmission
Manual gearbox 02C
Self diagnosis, V.A.G Inspection Service
Electric/Electronic components and fitting locations
Removing and installing the four-wheel drive control unit J492
Removing and installing the four-wheel drive control unit J492
Removing and installing the four-wheel drive control unit -J492-
Removing
–
Switch off ignition.
–
Disconnect the plug connection at rear final drive and pull the plug from the holder.
–
Disconnect plug of pump for Haldex coupling
-arrow 1-
.
–
Place a catch pan under the final drive.
–
Remove screws
-arrows 2-
.
–
Remove control unit.
Install
Installation is carried out in the reverse order. Pay attention to the following:
–
Replace O-rings
-A-
and
-B-
.
–
Tighten screws to 6 Nm.
–
Check oil level in Haldex coupling
→ Chapter
, if necessary change oil in Haldex coupling
→ Chapter
.
Power transmission
Manual gearbox 02C
Self diagnosis, V.A.G Inspection Service
Electric/Electronic components and fitting locations
Removing and installing the four-wheel drive control unit J492
Removing and installing pump for Haldex coupling V181 >
< Electric/Electronic components and fitting locations