skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Differential gear > < Removing

Octavia Mk1

Install
Install
–  Clean the gasket ring seat in the gearbox.
   
–  Insert gasket ring together with bushing.
A - Screw threaded rod from assembly device -MP3-434 (3066)- into the threaded part of the differential.
B - Nut M12 with washer
–  By turning the nut -B- insert the gasket ring with the bushing over the pressure plate -T10148- up to the stop.
–  Fill half the space between the sealing lip and dust lip with sealing grease -G 052 128 A1-.
–  Insert the flange shaft.
–  Secure the flange shaft with the conical screw and tighten with tightening torque.
  N39-1188
–  If the oil return-flow line for the exhaust gas turbocharger was unscrewed at the engine, now install it again -arrow- → Engine → Rep. Gr.21.
–  Install drive shaft -1- on gearbox → Chassis → Rep. Gr.40.
  N39-0824
–  If present, install heat shield for drive shaft on the engine -arrows- → Chassis → Rep. Gr.40.
–  Inspecting gear oil → Chapter.
–  Install the noise insulation → Body Work → Rep. Gr.50.
  S39-0282
Tightening torque
Flange shaft on gearbox (conical screw)25 Nm

   

Differential gear > < Removing