Octavia Mk1
Removing and installing gearbox housing and shift mechanism up to gearbox manufacturing date 18 05 3 |
1 - | 25 Nm |
2 - | Flange shaft with pressure spring |
q | removing and installing → Chapter |
3 - | Reversing light switch -F4-, 20 Nm |
4 - | Sealing ring |
q | always replace → Electronic Catalogue of Original Parts |
5 - | Oil drain plug |
q | pay attention to different versions → Fig. |
q | Internal serration screw, 45 Nm |
q | Allan screw, 30 Nm |
6 - | Sealing ring |
q | if present, always replace → Electronic Catalogue of Original Parts |
7 - | Screw cap |
8 - | 20 Nm |
q | always replace → Electronic Catalogue of Original Parts |
9 - | 20 Nm |
q | for gearshift shaft Pos. 14 to screw cap Pos. 7 |
q | always replace → Electronic Catalogue of Original Parts |
10 - | O-ring |
q | always replace → Electronic Catalogue of Original Parts |
q | insert in the slot of the cap |
11 - | Securing screw, 15 Nm |
q | for sliding-block of the gearshift shaft |
q | always replace → Electronic Catalogue of Original Parts |
q | insert using locking agent -D 000 600 A2- |
12 - | 25 Nm and torque a further 45° |
q | with captive washer |
q | always replace → Electronic Catalogue of Original Parts |
13 - | 25 Nm and torque a further 45° |
q | without washer |
q | always replace → Electronic Catalogue of Original Parts |
14 - | Gearshift shaft |
q | Disassembling and assembling the gearshift mechanism on the gearbox side up to gearbox manufacturing date 18 05 3 → Chapter |
15 - | 20 Nm |
q | always replace → Electronic Catalogue of Original Parts |
16 - | Shift cover |
q | Disassembling and assembling the gearshift mechanism on the gearbox side up to gearbox manufacturing date 18 05 3 → Chapter |
17 - | Clutch housing |
q | Repairing → Chapter |
18 - | Gearbox housing |
q | Repairing → Chapter |
|