skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Adjusting washer table > < Setting output shaft gears 1 through 4

Octavia Mk1

Determine the adjusting washer
Determine the adjusting washer
The prescribed bearing preload is reached by removing the established measured value (0.14 mm) from the inserted adjusting washer (1.70 mm) and by adding a constant compression value (0.20 mm).
Example:
   
Thickness of the inserted adjusting washer1.70 mm
- measured value0.14 mm
+ Pre-load (constant)0.20 mm
Thickness of the adjusting washer1.76 mm

–  Determine thickness of the adjusting washer according to the table → Chapter. Part number → Electronic Catalogue of Original Parts.
   
–  Remove the gearbox housing and pull the outer ring/tapered-roller bearing out of the gearbox housing.
A - Countersupport, e.g. -Kukko 22/2-
B - Interior extractor 46...58 mm, e.g. -Kukko 21/7-
–  Remove the inserted adjusting washer (1.70 mm thick) from the gearbox housing.
  S35-0182

Adjusting washer table > < Setting output shaft gears 1 through 4