Octavia Mk1
Summary of components of cylinder head - engines with identification characters AVU, BFQ |
Note
Disassembling and assembling intake manifold → Chapter. |
1 - | Screw cap |
2 - | Gasket |
q | replace if damaged |
3 - | Breather housing |
q | to disassemble, turn to the left |
4 - | Oil deflector |
5 - | Camshaft position sensor -G163- |
q | for engines with identification characters BFQ |
6 - | Sealing ring |
q | replace if damaged |
q | before fitting moisten with clean engine oil |
7 - | Support |
8 - | 10 Nm |
9 - | Coolant regulator housing |
q | disassembling and assembling coolant regulator housing → Chapter |
10 - | Sealing ring |
q | replace |
11 - | 20 Nm |
12 - | Cylinder head gasket |
q | replace → Chapter |
13 - | Camshaft position sensor -G163- |
q | for engines with identification characters AVU |
14 - | Rear toothed belt guard |
15 - | 15 Nm |
16 - | Camshaft sprocket |
17 - | 100 Nm |
q | to release and tighten use counterholder -T30004- |
18 - | Woodruff key |
19 - | Cylinder head |
q | removing and installing → Chapter |
q | check for distortion → Chapter |
q | rework cylinder head → Chapter |
q | after replacing fill entire system with fresh coolant → Chapter |
20 - | Cylinder head bolt |
q | replace |
q | pay attention to order for slackening → Anchor |
q | pay attention to order for tightening → Anchor |
q | removing and installing with socket insert -T10070- |
21 - | Gasket for cylinder head cover |
q | replace if damaged |
q | press into the spacer sleeves |
22 - | Cylinder head cover |
q | when removing the screws, slacken from the outside to the inside |
q | when installing the screws, tighten from the inside to the outside |
23 - | Vent connection |
q | to the expansion reservoir |